Airmar 300WX Installationshandbuch PDF herunterladen (Seite 13)

CA/CR40/42/50/52 Installation manual Chapter 11

11.4 Place of installation of display unit

The display unit can be installed on desktop, wall surface, or ceiling. Determine

the place to install the display unit that is convenient for navigation and radar

operation after considering the following suggestions:

- there is a minimum clearance at the back of the unit of 15 cm (CA/CR40/42)

or 18cm (CA/CR50/52).

- you can see the ship’s bow when you raise your eyes from the display.

- there is limited exposure to direct sunlight - see environment temperature limits

in section 11.13 Specifications.

- there is good ventilation and minimum vibration.

- there is a minimum distance of 50 cm to a magnetic compass.

11.5 Installation of Radar supply box RS4050

The external power supply, RS4050, must be connected to the

CA/CR40/42/50/52

to run the radar function. Dimensions: H:125mm, L:222mm, D:81mm.

Connect power cable with 3 or 4 pin connector to the receptacle marked ‘PWR’

at the rear of the display unit, and the second 1.5m cable with 6-pin to the

receptacle between ‘ANT’ and ‘ALARM’ at the rear of the display unit.

) 2 variants, refer to RS4050 addendum: 183-0700-001 or 183-0700-003.

Cable to ship’s mains: 2x1.5



mm, max. 5 m long (not included).

White

Brown

Green

Grey

Yellow

ANT WI N D AL ARM NM E A2 NME A1 E CH O1 E CH O2 RADAR P W R

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Keine Kommentare

Airmar 300WX Installationshandbuch Seite 13